LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Body Control Module (BCM) - DTCS B1830-11 To U1433-24) >> Diagnosis And Testing >> B222C-00-Vehicle Configuration Not Programmed >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR ACTIVE DTC 
    1. With the scan tool, read the active DTCs.
    2. Cycle the ignition switch from off to on at least five times, leaving the ignition on for a minimum of 90 seconds per cycle.
    3. With the scan tool, read the active DTCs.

      Does the scan tool display this DTC as active?

      Yes 

      • Go To  2

      No 

      • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  2. CONFIGURE THE BCM TO THE VEHICLE 
    1. With the scan tool, program the BCM to the vehicle configuration.
    2. With the scan tool, erase BCM DTCs.
    3. Cycle the ignition switch from off to on at least five times, leaving the ignition on for a minimum of 90 seconds per cycle.
    4. With the scan tool, read the active DTCs.

      Does the scan tool display this DTC as active?

      Yes 

      • Inspect the wiring and connectors for damage or shorted circuits. If OK, replace and program the BCM in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Repair is complete.
scientia non olet · About LEMON Manuals