Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- INTERMITTENT CONDITION
- Turn the ignition on.
- With the scan tool, clear all DTCs.
- With the scan tool, read DTCs.
Does the scan tool display DTC: B2119-11-IGNITION RUN/ACC/SPAD CONTROL - CIRCUIT SHORT TO GROUND?
Yes
- Go To 2
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
- CHECK THE (P307) ACCESSORY DELAY RELAY CONTROL FOR A SHORT TO GROUND
Courtesy of CHRYSLER GROUP, LLC
- Turn the ignition off.
- Disconnect the Junction Block C2 harness connector.
- Disconnect the BCM E harness connector.
- Measure the resistance between ground and the (P307) Accessory Delay Relay Control circuit.
Is the resistance above 10k Ohms?
Yes
- Go To 3
No
- Repair the short to ground in the (P307) Accessory Delay Relay Control circuit.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
- CHECK THE BCM FOR CORRECT OPERATION
- Reconnect the BCM E harness connector.
- Turn the ignition on.
- Using a 12-volt test light connected to ground, check (P307) Accessory Delay Relay Control circuit at the Junction Block C2 harness connector.
- With the scan tool, actuate the Ignition RUN/ACC 2 output.
Does the test light illuminate brightly?
Yes
- Replace the Junction Block in accordance with the Service Information. Refer to JUNCTION BLOCK, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .