Pressure Bleeding Procedure
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Follow the pressure bleeder manufacturer's instructions for use of the pressure bleeding equipment.
- Install (special tool #6921, Cap, Master Cylinder) on the master cylinder fluid reservoir. Attach the fluid hose from the pressure bleeder to the fitting on (special tool #6921, Cap, Master Cylinder).
- Attach a clear plastic hose (1) to the bleeder screw and feed the hose into a clear jar (2) containing enough fresh brake fluid to submerge the end of the hose.
- Open the bleeder screw at least one full turn or more to obtain a steady stream of brake fluid.
- After approximately 120-240 ml (4-8 ounces) of fluid have been bled through the brake circuit and an air-free flow is maintained in the clear plastic hose and jar, close the bleeder screw.
- Repeat this procedure at all the remaining bleeder screws.
- Check and adjust brake fluid level to the FULL mark on the reservoir.
- Check brake pedal travel and feel. If pedal travel is excessive or if the pedal feels excessively spongy, some air may still be trapped in the system. Re-bleed the brakes as necessary including the IPB Caliper Brake Bleeding Procedure on the rear calipers as listed below.
- Test drive the vehicle to verify the brakes are operating properly and pedal feel is correct.