LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Base Brakes (Service Information)) >> Parking Brake >> Cable, Parking Brake, Front >> Removal >> With Hand Lever

With Hand Lever

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Center Console
GC0128503Courtesy of CHRYSLER GROUP, LLC
  1. Remove the floor center console. Refer to CONSOLE, CENTER, REMOVAL .
  2. Manually release the parking brake cable tension. Refer to PARKING BRAKE, STANDARD PROCEDURE .
  3. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    Fig 2: Cable Equalizer/Tensioner
    GC0128497Courtesy of CHRYSLER GROUP, LLC
  4. Remove the parking brake cable equalizer/bent nail tensioner (4) from the three parking brake cables (2, 3, 5).
  5. Collapse the front cable retainer fingers at the end of the cable housing where it contacts the intermediate bracket (1). Pull the cable (5) forward and remove it from the intermediate bracket.
    Fig 3: Cable Mounting To Underbody With Hand Lever
    GC0128504Courtesy of CHRYSLER GROUP, LLC
  6. Remove the screws (4) securing the front cable routing clamps (1, 5) to the underbody of the vehicle.
  7. Remove the cable routing clamps (1, 5) from the cable (6).
  8. Lower the vehicle.
    Fig 4: Cable Mounting To Hand Lever
    GC0128496Courtesy of CHRYSLER GROUP, LLC
  9. Remove the mounting screws (3) fastening the front cable (4) to the side of the parking brake lever (1).
  10. Remove the adjusting nut (2) from the end of the front parking brake cable.
  11. Remove the cable strand from the lever.
  12. Pull the cable seal loose from the floor pan and remove the front parking brake cable from the vehicle through the access hole in the floor pan.
scientia non olet · About LEMON Manuals