Diagnostic Test
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
CHECK FOR ACTIVE DTC
- Turn the ignition on.
- With the scan tool, record and erase the Hands Free Module DTCs.
- Cycle the ignition switch from on to off, wait five seconds and then back to on.
- With the scan tool, read the active Hands Free Module DTCs.
Does the scan tool display this DTC as active?
Yes
- Locate the incorrect component and replace as needed
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .