Diagnostic Test

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN INTERMITTENT CONDITION
1. Turn the ignition on and open one of the front doors.
  NOTE:
  A front door must remain open whenever checking or erasing Amplifier DTCs.
2. Turn the radio on.
3. With the scan tool, erase Amplifier DTCs.
4. With the scan tool, reset the amplifier.
5. With the scan tool, read Amplifier DTCs.
  Does the scan tool display active: B1488-00 CABIN EQ MISMATCH PERFORMANCE?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE CABIN EQUALIZATION CURVE NUMBER
1. With the scan tool in the BCM ECU Details Tab, Configuration button, record the Cabin Equalization Curve number.
2. With the scan tool in the AMP ECU Details Tab, Configuration button, record the True value.
  NOTE:
  The Cabin EQ Curve value found in the BCM should match the True value found in the AMP.
  
  Do the Cabin EQ settings match one another?
  
  Yes
  - Replace the Amplifier in accordance to the service information. Refer to AMPLIFIER, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
VERIFY COMMUNICATION WITH BCM
1. With the scan tool, read the active modules on the BUS.
  Does the scan tool show the BCM active on the BUS?
  
  Yes
  - Go To 4
  No
  - Refer to DIAGNOSIS AND TESTING and perform the No Response From Body Control Module (BCM) diagnostic procedure.
CHECK THE BCM FOR ACTIVE DTCs
1. With the scan tool, erase BCM DTCs.
2. Turn the ignition off. Wait approximately 10 seconds.
3. Turn the ignition on.
4. With the scan tool, read BCM DTCs.
  Are any active DTCs present?
  
  Yes
  - Refer to BODY CONTROL MODULE (BCM) - DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic procedure.
  No
  - Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .