LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Telematics Gateway Module - Electrical Diagnostics) >> DTC Troubleshooting >> B143A-13-Microphone 1 - Circuit Open >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR AN ACTIVE DTC 
    NOTE:

    Verify the connection of the Rearview Mirror harness connector.

    1. Turn the ignition on.
    2. With the scan tool, read the active DTCs.

      Does the scan tool display: B143A-13-MICROPHONE 1 - CIRCUIT OPEN as active?

      Yes 

      • Go To  2

      No 

      • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  2. CHECK THE INSIDE REARVIEW MIRROR 
    1. Turn the ignition off.
    2. Disconnect the Inside Rearview Mirror harness connector
    3. Connect a jumper wire between the (X792) Microphone 1 IN (-) and the (X712) Microphone 1 IN (+) circuits.
    4. Turn the ignition on.
    5. With the scan tool, read the DTCs.
      NOTE:

      B143A-2B-MICROPHONE 1 - WIRES SHORTED TOGETHER should display as active as a result of this test.

      Does the scan tool display: B143A-13-MICROPHONE 1 - CIRCUIT OPEN as active?

      Yes 

      • Go To  3

      No 

      • Replace the Inside Rearview Mirror in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  3. CHECK THE (X712) MICROPHONE 1 IN (+) CIRCUIT FOR AN OPEN 
    1. Turn the ignition off.
    2. Disconnect the TGW harness connector.
    3. Measure the resistance of the (X712) Microphone 1 IN (+) circuit between the Inside Rearview Mirror and TGW harness connectors.

      Is the resistance below 5 Ohms?

      Yes 

      • Go To  4

      No 

      • Repair the (X712) Microphone 1 IN (+) circuit for an open.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  4. CHECK THE (X792) MICROPHONE 1 IN (-) CIRCUIT FOR AN OPEN 
    1. Measure the resistance of the (X792) Microphone 1 IN (-) circuit between the Inside Rearview Mirror and TGW harness connectors.

      Is the resistance below 5 Ohms?

      Yes 

      • Replace the TGW in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Repair the (X792) Microphone 1 IN (-) circuit for an open.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals