LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 ((Tire Pressure Module (TPM) - Electrical Diagnostics)) >> DTC Troubleshooting >> C1502-96-Tire Pressure Sensor 2 - Internal Component Failure >> Set Condition

Set Condition

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

The TPM Module will monitor the signals from the four active road tire TPM Sensors. A loss of RF signal error is detected if data is not received or cannot be accurately decoded for a maximum of 20 minutes when the vehicle speed is above 24 km/h (15 mph). An internal sensor hardware error condition will be set when an error in the shock sensor, pressure sensor, or temperature sensor is detected. The Tire Pressure Monitoring Telltale Lamp will flash on and off for 75 seconds then remain on solid when a system fault is detected.

scientia non olet · About LEMON Manuals