LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Power Locks (Service Information)) >> Antenna, Passive Entry >> Removal >> Rear Floor Panel

Rear Floor Panel

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Wire Harness Connector, Low Frequency (LF) Antenna & Rear Floor Panel
GC0147722Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the second row seat cushion from the rear floor panel. Refer to SEAT, REMOVAL .
  3. Raise the rear edge of the rear floor carpet far enough to access and disconnect the wire harness connector (3) from the connector receptacle for the Low Frequency (LF) antenna (5) on the rear floor panel (1).
  4. Remove the two screws (2) that secure the LF antenna to the two plastic nuts (4) in the rear floor panel.
  5. Remove the LF antenna from the vehicle.
scientia non olet · About LEMON Manuals