LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Lamps/Lighting - Interior (Service Information)) >> Lamp, Dome, Reading >> Removal >> Lamp - Light Emitting Diode >> Except With Overhead Console

Except With Overhead Console

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Light Emitting Diode (Except With Overhead Console)
GC0128646Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Insert the tip of a small flat bladed screwdriver into the notch (1) between the dome/reading lamp bezel and the lock tab between the two Light Emitting Diode (LED) pod units.
  3. Gently pry the lock tab downward until it unsnaps from the lamp bezel.
  4. Swing the lock tab downward until it is perpendicular to the lamp bezel.
  5. Pull the lamp away from the headliner mounting hole far enough to access and disconnect the wire harness connector from the back of the lamp.
  6. Remove the lamp from the vehicle.
scientia non olet · About LEMON Manuals