Standard Procedure - Flashlight Battery Replacement
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- Insert a small screwdriver or another suitable tool into each of the two notches (2) between the upper (1) and lower (3) case halves of the flashlight and use a twisting action to separate the case.
- Remove the lower case (4) from the upper case (3) and set it aside.
- Lightly lift the latch tab (2) at the back of the upper case and slide the battery (1) rearward far enough to remove it from the case.
- Install the new battery by sliding it between the latch tab and the case until it is engaged by the latch tab. The battery must be installed with the positive (+ ) terminal oriented toward the upper case (3).