LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Ignition System (Service Information)) >> Sensor, Camshaft Position >> Installation >> 2.4L Rear

2.4L Rear

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cam Sensor
GC0082375Courtesy of CHRYSLER GROUP, LLC
CAUTION:

Install camshaft position (CMP) sensor utilizing twisting motion. Make sure CMP sensor is fully seated. Do not drive CMP sensor into the bore with mounting screw. This may cause CMP sensor to be incorrectly seated causing a faulty signal or no signal at all.

  1. Lubricate sensor O-ring.
  2. Install CMP sensor and mounting bolt, tighten to 9 N.m (79.5 in. lbs.).
    Fig 2: Rear Cam Sensor Shield Removed
    GC0082377Courtesy of CHRYSLER GROUP, LLC
  3. Connect electrical connector to camshaft position sensor.
  4. Install heat shield onto mounting stud.
  5. Install heat shield retaining nut and tighten.
    Fig 3: Rear Cam Sensor Shield Installed
    GC0082376Courtesy of CHRYSLER GROUP, LLC
  6. Connect the electrical connector.
  7. Connect negative battery cable, tighten nut to 5 N.m (45 in. lbs.).
scientia non olet · About LEMON Manuals