LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Exhaust System) >> Pipe, Exhaust Cross-Under >> Installation >> 3.6L

Pipe, Exhaust Cross-Under: Installation: 3.6L

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Two Cross-Under Support, Front Flange Nuts & Rear Flange Bolts
GC0147004Courtesy of CHRYSLER GROUP, LLC
  1. Position new gaskets onto the catalytic converter flanges.
  2. Position the cross-under pipe (1) into its position between the catalytic converters.
  3. Install the front flange mounting nuts (4). Tighten nuts to 28 Nm (250 in.-lbs.).
  4. Install the rear flange bolts (5). Tighten bolts to 30 N.m (22 ft. lbs.).
  5. Install the cross-under support (2) bolts. Tighten nuts to 28 Nm (250 in.-lbs.).
    Fig 2: Cross-Under Pipe
    GC0147005Courtesy of CHRYSLER GROUP, LLC
  6. Install the muffler/resonator pipe (2) onto the cross-under pipe (4). Do not tighten the pipe clamp.
  7. Install the half shaft. Refer to INSTALLATION .
    Fig 3: Front Muffler/Resonator Pipe Grommet
    GC0147009Courtesy of CHRYSLER GROUP, LLC
  8. Install the front pipe grommet (4).
  9. Check for clearance of the exhaust to body.
  10. Tighten the muffler/resonator pipe clamp (3) to 55 N.m (40 ft. lbs.).
scientia non olet · About LEMON Manuals