2.0L Diesel

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: DPF Flange, Gasket, Exhaust Cross-Under Pipe & Fasteners

Courtesy of CHRYSLER GROUP, LLC

Position new gasket (3) onto the diesel particulate filter (DPF) flange (2).
Position the cross-under pipe (5) into its position onto the DPF flange (2).
Install the front flange mounting nuts (4). Tighten nuts to 27 N.m (250 in. lbs.).
Install the rear flange bolt (5). Tighten bolt to 30 N.m (22 ft. lbs.).

Fig 2: Clamp, Down Pipe & Cross-Under Pipe
Courtesy of CHRYSLER GROUP, LLC
Install the down pipe (1) onto the cross-under pipe (3). Tighten the pipe clamp (2) to 50 N.m (37 ft. lbs.).
Check for clearance of the exhaust to body.

Fig 3: Engine Belly Pan & Fasteners
Courtesy of CHRYSLER GROUP, LLC
If equipped, install the lower engine bellypan shield.
Lower the vehicle.
Connect the negative battery cable.