LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Fuel System) >> Fuel Injection, Gas >> Injector(S), Fuel >> Installation >> 2.4L

Injector(S), Fuel: Installation: 2.4L

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Fuel Injector And Rail
GC0082493Courtesy of CHRYSLER GROUP, LLC
  1. Apply a light coating of clean engine oil to the upper O-ring.
  2. Install injector in cup on fuel rail.
    Fig 2: Fuel Injector On Rail
    GC0082492Courtesy of CHRYSLER GROUP, LLC
  3. Install retaining clip.
    Fig 3: Rail Removal/Install
    GC0082491Courtesy of CHRYSLER GROUP, LLC
  4. Apply a light coating of clean engine oil to the O-ring on the nozzle end of each injector.
  5. Insert fuel injector nozzles into openings in lower intake manifold. Seat the injectors in place.
    Fig 4: Electrical Harness Removed
    GC0082490Courtesy of CHRYSLER GROUP, LLC
  6. Install fuel rail mounting screws, tighten to 27 N.m (20 ft. lbs.).
    Fig 5: Harness Clips
    GC0082489Courtesy of CHRYSLER GROUP, LLC
  7. Install wiring harness clips to the fuel rail mounting studs.
    Fig 6: Fuel Injector Electrical Connectors
    GC0082488Courtesy of CHRYSLER GROUP, LLC
  8. Connect and lock the electrical connectors to the fuel injectors.
    Fig 7: Fuel Line At Rail
    GC0082487Courtesy of CHRYSLER GROUP, LLC
  9. Connect fuel supply tube to fuel rail. Refer to FITTING, QUICK CONNECT  .
  10. Connect negative battery cable, tighten nut to 5 N.m (45 in. lbs.).
  11. Use the scan tool to pressurize the fuel system. Check for leaks.
  12. Install engine cover.
scientia non olet · About LEMON Manuals