LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Starting System (Service Information)) >> Starter >> Removal >> 2.4L

Section 39 (Starting System (Service Information)): Starter: Removal: 2.4L

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing & Installing Starter Motor
GC0128595Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove throttle body. Refer to THROTTLE BODY, REMOVAL .
  3. Remove starter mounting bolts (1) and negative battery cable (2) from transmission housing (3).
  4. Remove starter motor (4) from transmission housing (3).
    Fig 2: Rotating Starter
    GC0082364Courtesy of CHRYSLER GROUP, LLC
  5. Position starter to move past the intake manifold.
    Fig 3: 2.4L Electrical Connection
    GC0128596Courtesy of CHRYSLER GROUP, LLC
  6. Remove battery cable nut (5), ignition sense wire (4) and battery cable (1) from solenoid stud.
  7. Disconnect electrical connector (3) from starter solenoid (2).
  8. Remove starter from vehicle.
scientia non olet · About LEMON Manuals