Second Row
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
The second row intrusion module sensor is attached to the second row seating overhead lamp retainer lever and is available for separate service replacement.
- Disconnect and isolate the negative cable from the battery.
- Remove the second row seating overhead lamp (1) from the headliner. Refer to LAMP, DOME, READING, REMOVAL .
- Access the intrusion module sensor transducer on the inside surface of the overhead lamp retainer lever (2) and rotate it counterclockwise about 30 degrees to disengage it from the receptacle.
- Disconnect the intrusion module sensor pigtail wire from the jumper wire harness above the headliner and remove the sensor.