Second Row
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
The second row intrusion module sensor is attached to the second row seating overhead lamp retainer lever and is available for separate service replacement.
- Position the intrusion module sensor close enough to the headliner overhead lamp opening to access and reconnect the sensor pigtail wire to the jumper wire harness above the headliner.
- Position the intrusion module sensor transducer to the receptacle on the inside surface of the overhead lamp retainer lever (2) and rotate it clockwise about 30 degrees to engage it with the receptacle.
- Reinstall the second row seating overhead lamp (1) to the headliner. Refer to LAMP, DOME, READING, INSTALLATION .
- Reconnect the negative cable to the battery.