LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Engine Cooling System) >> Engine >> Sensor, Coolant Temperature >> Installation >> 2.0L Diesel

2.0L Diesel

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Coolant Temperature (ECT) Sensor
GC0147931Courtesy of CHRYSLER GROUP, LLC
  1. Apply MOPAR® thread sealant with PFTE part number 04318034 to sensor threads.
  2. Install the Engine Cooling Temperature (ECT) sensor (2) to cylinder head. Tighten sensor to 11 N.m (97 in. lbs.).
  3. Connect the ECT sensor wire harness connector.
  4. Install the engine cover.
  5. Replace any lost engine coolant. Refer to STANDARD PROCEDURE .
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals