Belt, Serpentine: Installation: 2.4L
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - POWER STEERING PUMP |
| 2 - ACCESSORY DRIVE BELT |
| 3 - GENERATOR |
| 4 -AIR CONDITIONING COMPRESSOR |
| 5 - LOWER IDLER PULLEY |
| 6 - CRANKSHAFT PULLEY |
| 7 - WATER PUMP PULLEY |
| 8 - ACCESSORY DRIVE BELT TENSIONER |
| 9 - UPPER IDLER PULLEY |
NOTE:
When installing the drive belt on the pulleys, make sure that the belt is properly routed and all V-grooves.
- Install the accessory drive belt (2) around all the pulleys except for the generator pulley (3).
- Using a wrench, rotate accessory drive belt tensioner (8) counterclockwise until accessory drive belt (2) can be installed on the generator pulley (3). Slowly release the tensioner to tighten the belt on all of the pulleys.
- Verify that the belt is seated correctly on all of the pulleys.