Without Third Row Seating

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Before proceeding, refer to WARNING .

Remove four nuts, remove load floor.
Open access panel by breaking perforations along panel, then folding panel upward.
Move insulation out of the way to access shock assembly upper mounting nuts.

Fig 1: Upper Shock Mounting
Courtesy of CHRYSLER GROUP, LLC
Remove the two nuts (1) securing the shock assembly to the body bracket (2).
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Fig 2: Tire & Wheel Mounting
Courtesy of CHRYSLER GROUP, LLC
Remove the wheel mounting nuts (3), then the rear tire and wheel assembly.

Fig 3: Supporting Rear Shock
Courtesy of CHRYSLER GROUP, LLC
If equipped with load-leveling shocks, support the lower shock (1) with a jack (2) using just enough force to allow easy removal of the lower shock mounting bolt in the following step. Lower the jack following bolt removal.

Fig 4: Rear Lower Shock Mounting
Courtesy of CHRYSLER GROUP, LLC
Remove the lower shock mounting nut (1) and bolt (4).
Lower the shock assembly (2) out of the body bracket and lift out over rear suspension.