LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 238 ((Amplifier (Amp) - Electrical Diagnostics - Base)) >> DTC Troubleshooting >> B14CA-Channel 12 Audio Speaker Output Circuit High >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR AN ACTIVE DTC 
    1. Turn the ignition on and open one of the front doors.
      NOTE:

      A front door must remain open whenever checking or erasing Amplifier DTCs.

    2. With the scan tool, read Amplifier DTCs and record on the repair order.
    3. With the scan tool, erase DTCs.
    4. Cycle the ignition switch from on to off, wait five seconds and then back to on.
    5. Turn the Radio on.
    6. Adjust the speakers to the rear and center.
    7. With the scan tool, read Amplifier DTCs.

      Did the DTC return?

      Yes 

      • Go To  2

      No 

      • The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  2. CHECK FOR VOLTAGE ON THE (X306) SUBWOOFER 4 INPUT (+) CIRCUIT 
    1. Turn the ignition off.
    2. Disconnect the Amplifier C2 harness connector.
    3. Disconnect the Subwoofer Speaker harness connector.
    4. Turn the ignition on.
    5. Measure the voltage between ground and the (X306) Subwoofer 4 Input (+) circuit at the Amplifier C2 harness connector.

      Is there any voltage present?

      Yes 

      • Repair the (X306) Subwoofer 4 Input (+) circuit for a short to voltage.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Go To  3
  3. CHECK FOR VOLTAGE ON THE (X396) SUBWOOFER 4 INPUT (-) CIRCUIT 
    1. Measure the voltage between ground and the (X396) Subwoofer 4 Input (-) circuit at the Amplifier C2 harness connector.

      Is there any voltage present?

      Yes 

      • Repair the (X396) Subwoofer 4 Input (-) circuit for a short to voltage.
      • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

scientia non olet · About LEMON Manuals