Diagnostic Test

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN INTERMITTENT CONDITION
1. Turn the ignition on.
2. Using the scan tool, record and erase the Amplifier DTCs.
3. Cycle the ignition switch from on to off, wait five seconds and then back to on.
4. Turn the Radio on and set the volume to 25.
5. Adjust the speakers to the rear and center.
6. Using the scan tool, read the active Amplifier DTCs.
  Does the scan tool display active: B147C-CHANNEL 6 AUDIO SPEAKER OUTPUT CIRCUIT OPEN?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE OPERATION OF THE RIGHT REAR SPEAKER

Fig 1: Measuring Voltage Between Right Rear Speaker (+) Circuit & Right Rear Speaker (-) Circuits
Courtesy of CHRYSLER GROUP, LLC
1. Using the scan tool, erase the DTCs.
2. Turn the ignition off.
3. Disconnect the Right Rear Speaker harness connector from the Right Rear Speaker.
4. Turn the ignition on.
5. Turn the radio on and set the volume to 25.
6. With a Voltmeter set to read in A/C voltage, measure the voltage between the (X205) Right Rear Speaker (+) circuit and the (X295) Right Rear Speaker (-) circuits in the Right Rear Speaker connector.
  Is the voltage present greater than 1 Volt in the Right Rear Speaker connector?
  
  Yes
  - Replace the Right Rear Speaker.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
CHECK THE (X206) RIGHT REAR SPEAKER (+) CIRCUIT FOR AN OPEN

Fig 2: Measuring Resistance Of Right Rear Speaker (+) Circuit
Courtesy of CHRYSLER GROUP, LLC
1. Turn the ignition off.
2. Disconnect the Amplifier C2 harness connector.
3. Measure the resistance of the (X206) Right Rear Speaker (+) circuit between the Amplifier C2 harness connector and the Right Rear Speaker harness connector.
  Is the resistance below 2.0 Ohms?
  
  Yes
  - Go To 4
  No
  - Repair the (X206) Right Rear Speaker (+) circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (X296) RIGHT REAR SPEAKER (-) CIRCUIT FOR AN OPEN

Fig 3: Measuring Resistance Of Right Rear Speaker (-) Circuit
Courtesy of CHRYSLER GROUP, LLC
1. Measure the resistance of the (X296) Right Rear Speaker (-) circuit between the Amplifier C2 harness connector and the Right Rear Speaker harness connector.
  Is the resistance below 2.0 Ohms?
  
  Yes
  - Replace the Amplifier in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Repair the (X296) Right Rear Speaker (-) circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .