Instrument Panel - Passenger Side

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery negative cable.
Remove the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL .
Remove the instrument panel end cap.

Fig 1: Speaker & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove the two speaker (1) fasteners (2) through end cap opening.

Fig 2: Speaker Fastener & Glove Box Opening
Courtesy of CHRYSLER GROUP, LLC
Remove the speaker (2) fastener (1) through glove box opening.

Fig 3: Speaker Electrical Connector & Instrument Panel Wiring Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the speaker electrical connector (1) from the instrument panel wiring harness connector (2).
Remove the speaker through the glove box opening.