LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 ((Wireless Control Module (WCM) - Electrical Diagnostics)) >> DTC Troubleshooting >> P1605 Ignition Switch >> Set Condition

Set Condition

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

If the Ignition Switch Sense Enabled shows "TRUE" and the action status in the Data Display screen shows SNA (Signal Not Available) for more than 5 seconds the fault will set as active.

scientia non olet · About LEMON Manuals