Diagnostic Test

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK POWER TO HEATED SEATS MODULE

Fig 1: Checking Heated Seats Module For Power
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Check the related TIPM fuse. Repair if necessary.
1. Turn the ignition off.
2. Disconnect the Heated Seats Module harness connector.
3. Turn the ignition on.
4. Using a 12-volt test light connected to ground, check the (P693) Fused Run Relay Output circuit at the Heated Seat Module harness connector.
  NOTE:
  The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.
  
  Does the test light illuminate brightly?
  
  Yes
  - Go To 3
  No
  - Repair the open in the (P693) Fused Run Relay Output circuit. Inspect the related fuse. If the fuse is open, check the circuit for a short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK (D506) LIN BUS CIRCUIT VOLTAGE TO HEATED SEATS MODULE

Fig 2: Measuring Voltage Of LIN Bus Circuit Between Heated Seats Module Harness Connector & Ground
Courtesy of CHRYSLER GROUP, LLC
1. Measure the voltage of the (D506) LIN BUS circuit between the Heated Seats Module harness connector and ground.
  Is the voltage above 5.0 volts?
  
  Yes
  - Go To 4
  No
  - Repair the open in the (D506) LIN BUS circuit.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK (Z911) GROUND CIRCUIT FOR AN OPEN

Fig 3: Checking Ground Circuit For Open
Courtesy of CHRYSLER GROUP, LLC
1. Using a 12-volt test light connected to 12 volts, check the (Z911) Ground circuit at the Heated Seats Module harness connector.
  NOTE:
  The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.
  
  Does the test light illuminate brightly?
  
  Yes
  - Replace the Heated Seats Module in accordance with the service information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Repair the (Z911) ground circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .