Diagnostic Test

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC

NOTE:

Before proceeding with this diagnostic procedure, verify the Left and Right Steering Wheel Switch and Clockspring harness connectors are properly seated and verify proper pin terminal tension. A loose connection at any of these connectors may cause this DTC to set.

Turn the ignition on.
With the scan tool, read DTCs.
Does the scan tool display this DTC as active?

Yes
- Replace the Left Steering Wheel Switch in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.