Diagnostic Test
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
CHECK FOR AN ACTIVE DTC
NOTE:
Diagnose and repair all LIN Bus related DTCs before performing this test procedure.
- Turn the ignition on.
- Inspect the Right Heated Seat switch for anything that would cause it to stay or stick in a pushed position.
- Press and release the Right Heated Seat switch several times and then wait 20 seconds.
- With a scan tool, read DTCs.
Does the scan tool display this DTC as active?
Yes
- Replace the Switch Bank in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.