LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 230 (Charging System (Service Information)) >> Generator >> Removal >> 2.8L

Section 230 (Charging System (Service Information)): Generator: Removal: 2.8L

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Generator Electrical Connector - 2.8L Diesel
GC0130761Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable at battery.
  2. Disconnect the field wire connector (2) at side of generator by pushing on connector tab.
  3. Remove the B+ cable output terminal mounting nut (1). Disconnect terminal from generator.
  4. Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
    Fig 2: Generator Mounting - 2.8L Diesel
    GC0130762Courtesy of CHRYSLER GROUP, LLC
  5. Remove the two upper generator mounting bolts (1).
  6. Remove the two lower generator mounting bolts (2).
  7. Remove the generator from the vehicle.
scientia non olet · About LEMON Manuals