Fastener Torque Specifications
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
FASTENER TORQUE SPECIFICATIONS TABLE
| Description | N.m | Ft. Lbs. | In. Lbs. | NEW FASTENER* |
|---|---|---|---|---|
| A/C Compressor Bolts | Specific fastener placement and torque pattern required. Refer to COMPRESSOR, A/C, INSTALLATION . | |||
| A/C Compressor Clutch Coil Screws | 5 | - | 44 | |
| A/C Compressor Shaft Bolt | 20 | - | 177 | |
| A/C Compressor Coil Connector Bracket Screw | 4.3 | - | 38 | |
| A/C Condenser to Radiator Bolts | 5 | - | 45 | |
| Air Inlet Housing to Instrument Panel Support Bolts | 4 | - | 35 | |
| Discharge Line to Condenser Nut | 23 | 17 | - | |
| Discharge Line to Compressor Nut | 23 | 17 | - | |
| Expansion Valve Bolts | 11 | - | 97 | |
| HVAC Housing to Instrument Panel Support Bolts | 4 | - | 35 | |
| Liquid Line to Condenser Nut | 23 | 17 | - | |
| Receiver/Drier to Condenser Bolt | 22 | 16 | - | |
| Suction Line to Compressor Nut | 23 | 17 | - | |
| Suction and Liquid Lines to Expansion Valve Nut | 20 | - | 177 | |
| *NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. | ||||