LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Heating & Air Conditioning (Service Information)) >> Plumbing >> Compressor, A/C >> Diagnosis And Testing >> A/C Clutch Coil >> Coil Resistance Test

Coil Resistance Test

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the wire harness connector from the A/C clutch coil connector.
  3. Use an ohmmeter and Back Probe Tool (special tool #6801, Terminal Probe) and measure the resistance of the A/C clutch coil at the coil connector terminals.
  4. See A/C CLUTCH COIL SPECIFICATIONS  for the acceptable A/C clutch coil resistance. Specifications apply for a work area temperature of 21° C (70° F).
    1. If the A/C clutch coil reading is below specifications, the coil is shorted and must be replaced.
    2. If the A/C clutch coil reading is above specifications, the coil is open and must be replaced.
scientia non olet · About LEMON Manuals