LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Heating & Air Conditioning (Service Information)) >> Controls >> Transducer, A/C Pressure >> Removal >> Removal

Transducer, A/C Pressure: Removal: Removal

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.

Fig 1: Removing/Installing A/C Pressure Transducer
GC0082715Courtesy of CHRYSLER GROUP, LLC
NOTE:

Typical A/C pressure transducer and refrigerant line shown.

  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the wire harness connector (1) from the A/C pressure transducer (2).
  3. Remove the A/C pressure transducer from the fitting (3) located on either the A/C liquid line or A/C discharge line, depending on engine application.
  4. Remove and discard the O-ring seal (4).
scientia non olet · About LEMON Manuals