Solenoid, Variable Valve Timing [ERB, ERC, ERD]: Removal: Right

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect and isolate the negative battery cable.
Remove the engine cover. Refer to COVER, ENGINE, REMOVAL .

Fig 1: Heater Core Return Hose, Heater Core Supply Hose, Nuts & Oil Cooler Return Hose
Courtesy of CHRYSLER GROUP, LLC
Remove two nuts (3) and reposition the heater core tube assembly.

Fig 2: Variable Valve Timing Solenoids, Connectors & Bolts
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Mark the variable valve timing solenoid connectors (1) with a paint pen or equivalent so that they may be reinstalled in their original locations.
Mark the intake variable valve timing solenoid (2) and the exhaust variable valve timing solenoid (4) with a paint pen or equivalent so that they may be reinstalled in their original locations.
Disconnect the electrical connector (1) from the variable valve timing solenoid.
Remove the variable valve timing solenoid mounting bolts (3).

Fig 3: VVT Seal
Courtesy of CHRYSLER GROUP, LLC
Pull the variable valve timing solenoid from the cylinder head cover.
The seal (1) can be reused if not damaged.