LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Starting System (Service Information)) >> Starter >> Removal >> 3.6L

Section 221 (Starting System (Service Information)): Starter: Removal: 3.6L

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Starter Solenoid Electrical Connector, Solenoid Stud, Starter Mounting Bolts & Starter Assembly
GC0144659Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Disconnect the starter solenoid electrical connector (1) from the starter solenoid terminal.
  4. Remove the battery cable nut and battery cable from the solenoid stud (2).
  5. Remove the starter mounting bolts (4).
  6. Remove the starter assembly (3) from the transmission.
scientia non olet · About LEMON Manuals