LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Starting System (Service Information)) >> Starter >> Installation >> 2.8L Diesel (Manual Trans)

2.8L Diesel (Manual Trans)

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: B+ Cable & Retainer
GC0130768Courtesy of CHRYSLER GROUP, LLC
  1. Connect solenoid terminal wire harness connector to starter solenoid. Always support starter motor during this process. Do not let starter motor hang from wire harness.
  2. Install battery cable eyelet onto starter solenoid stud. Install and tighten nut (1). Refer to TORQUE  Specifications.
    Fig 2: Starter Mounting 2.8L Diesel
    GC0085600Courtesy of CHRYSLER GROUP, LLC
  3. Position starter motor to transmission. Install and tighten two mounting bolts (2). Refer to TORQUE  Specifications.
  4. Lower vehicle.
  5. Connect negative battery cable.
scientia non olet · About LEMON Manuals