LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Starting System (Service Information)) >> Starter >> Installation >> 2.8L Diesel (Auto Trans)

2.8L Diesel (Auto Trans)

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: B+ Cable & Retainer
GC0130768Courtesy of CHRYSLER GROUP, LLC
NOTE:

Always support starter motor during this process. Do not let starter motor hang from wire harness.

  1. Install the B+ cable and install the B+ cable retainer (1).
  2. Install the solenoid terminal connector to the starter solenoid.
  3. Install the starter motor.
    Fig 2: Starter Motor & Two Bolts
    GC0148263Courtesy of CHRYSLER GROUP, LLC
  4. While supporting the starter motor (1), install the two bolts (2) securing the starter motor to the transmission.
  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals