LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Vehicle Theft Security (Service Information)) >> Switch, Hood Ajar >> Removal >> Single Bracket

Single Bracket

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remote Start Hood Ajar Switch
GC0148396Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable or the Intelligent Battery Sensor (IBS) and negative cable assembly (as equipped) from the negative terminal post of the battery.
  2. Remove the remote start hood ajar switch (1) from the mounting bracket. Refer to SWITCH, HOOD AJAR, REMOVAL .
    Fig 2: Retainer & Remote Start Hood Ajar Switch Bracket
    GC0148397Courtesy of CHRYSLER GROUP, LLC
  3. Remove the screw (1) that secures the remote start hood ajar switch bracket (2) to the front of the left front load beam in the engine compartment.
  4. Remove the hood ajar switch bracket (2) from the load beam.
scientia non olet · About LEMON Manuals