LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Vehicle Theft Security (Service Information)) >> Switch, Hood Ajar >> Removal >> Dual Switch

Dual Switch

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Mounting Bracket, Two Remote Start And Stop/Start Switch Latch Tabs & Harness Connector
GC0148403Courtesy of CHRYSLER GROUP, LLC
  1. Open the hood.
  2. Disconnect and isolate the negative cable from the battery.
  3. From the top of the mounting bracket (3) in the left front corner of the engine compartment, squeeze the two Remote Start and Stop/Start switch latch tabs (1) together and pull the switch upward.
  4. Pull the Remote Start and Stop/Start switch up through the hole in the mounting bracket far enough to access and disconnect the harness connector (2) from the switch connector receptacle.
  5. Remove the Remote Start and Stop/Start switch from the engine compartment.
scientia non olet · About LEMON Manuals