LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Vehicle Theft Security (Service Information)) >> Switch, Hood Ajar >> Removal >> Dual Bracket

Dual Bracket

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Start And Stop/Start Switches
GC0148399Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable or the Intelligent Battery Sensor (IBS) and negative cable assembly (as equipped) from the negative terminal post of the battery.
  2. Remove the remote start and stop/start hood ajar switches (1) from the mounting bracket. Refer to SWITCH, HOOD AJAR, REMOVAL .
    Fig 2: Bracket Mounting Retainer, Stop/Start Switch Bracket & Front Load Beam
    GC0148401Courtesy of CHRYSLER GROUP, LLC
  3. Remove the screw (1) that secures the mounting bracket (2) to the left front load beam (3) in the engine compartment.
  4. Remove the hood ajar switch mounting bracket (2) from the load beam.
scientia non olet · About LEMON Manuals