LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Vehicle Theft Security (Service Information)) >> Switch, Hood Ajar >> Installation >> Single Switch

Single Switch

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Mounting Bracket, Two Remote Start Hood Ajar Switch Latch Tabs, Mounting Bracket & Harness Connector
GC0148398Courtesy of CHRYSLER GROUP, LLC
  1. Position the remote start hood ajar switch near the hole in the mounting bracket (3) on the front of the left load beam in the left front corner of the engine compartment.
  2. Route the harness connector (2) through the switch mounting bracket (3) and connect it to the switch connector receptacle.
  3. From the top of the mounting bracket, press the switch downward into the mounting hole until the integral switch latch tabs lock it into place.
  4. If equipped with IBS, connect the IBS/negative battery cable assembly to the negative battery post.
  5. Reconnect the negative cable to the battery.
  6. Close and latch the hood.
scientia non olet · About LEMON Manuals