LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Vehicle Theft Security (Service Information)) >> Siren >> Removal >> Gasoline Engine

Gasoline Engine

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Siren Module Components
GC0130835Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable from the battery.
  2. Locate the alarm siren module (1) on the component tray on the inboard side of the right front fender load path beam (3).
  3. Disconnect the engine compartment wire harness connector from the connector receptacle of the siren.
  4. Remove the screw (2) that secures the siren mounting bracket to the U-nut and stanchion on the component tray.
  5. Remove the siren and mounting bracket from the component tray as a unit.
scientia non olet · About LEMON Manuals