LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Vehicle Theft Security (Service Information)) >> Siren >> Removal >> Diesel Engine

Diesel Engine

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Diesel Engine Components (Siren)
GC0130834Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable from the battery.
  2. Locate the alarm siren module (3) on the inboard side of the left front fender load path beam (2).
  3. Disconnect the engine compartment wire harness connector (4) from the connector receptacle for the siren.
  4. Remove the two screws (1) that secure the siren mounting bracket to the spring nuts in the load path beam.
  5. Remove the siren and mounting bracket from the load path beam as a unit.
scientia non olet · About LEMON Manuals