LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Vehicle Theft Security (Service Information)) >> Sensor, Intrusion Module >> Removal >> Swing Gate

Swing Gate

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

An intrusion sensor is installed within the swing gate only on vehicles equipped with the export premium version of the Vehicle Theft Alarm (VTA).

  1. Disconnect and isolate the negative cable from the battery.
  2. Unlatch and open the swing gate.
  3. Unsnap the inboard side of the louvered plastic access panel and unhook it from the outboard edge of the access hole on the inside of the swing gate near the latch.
  4. Reach through the access hole to disconnect the intrusion sensor pigtail connector from the swing gate wire harness connector.
  5. Remove the fasteners securing the intrusion sensor to the inside of the swing gate.
  6. Remove the intrusion sensor from the swing gate.
scientia non olet · About LEMON Manuals