LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Vehicle Theft Security (Service Information)) >> Sensor, Intrusion Module >> Installation >> Swing Gate

Swing Gate

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

An intrusion sensor is installed within the swing gate only on vehicles equipped with the export premium version of the Vehicle Theft Alarm (VTA).

  1. Reach through the access hole on the inside of the swing gate near the latch to position the intrusion sensor to the inside of the swing gate.
  2. Install the fasteners that secure the intrusion sensor to the swing gate.
  3. Reconnect the intrusion sensor pigtail connector to the swing gate wire harness connector.
  4. Reinstall the louvered plastic access panel over the access hole by hooking it into the outboard edge of the hole, then pressing firmly and evenly over the two snap clip locations on the inboard side of the panel until it snaps into place.
  5. Reconnect the negative cable to the battery.
scientia non olet · About LEMON Manuals