Active Head Restraint (AHR)

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Unzip/Zipping Soft Back Cover Side Zippers

Courtesy of CHRYSLER GROUP, LLC

WARNING:

Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat air bags. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

WARNING:

Improper installation of the headrests may result in reduced protection of the occupants. If, after installation, the headrest can be removed, without simultaneously pressing the buttons on the master and slave guide sleeves, then the head restraint is installed incorrectly. Failure to follow these instructions may result in possible serious or fatal injury.

NOTE:

For reset procedures, refer to RESTRAINT, ACTIVE HEAD, STANDARD PROCEDURE .

Disconnect and isolate battery negative cable.
For seats equipped with a soft back cover (2), unzip one of the side zippers (1) to gain access to the AHR electrical connector.

Fig 2: Top Clips & Hard Back Seat Cover
Courtesy of CHRYSLER GROUP, LLC
For seats equipped with a hard back seat cover (2), using trim stick (special tool #C-4755, Trim Stick) or equivalent, release the top clips (1).

Fig 3: Separating/Positioning Lower Retaining Hooks And Removing/Installing Seat Back Cover
Courtesy of CHRYSLER GROUP, LLC
Separate the lower retaining hooks (2) and remove the seat back cover (3).

Fig 4: Identifying Electrical Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the electrical connector (1).

Fig 5: Release Button, Thin Wire Type Tool & AHR
Courtesy of CHRYSLER GROUP, LLC
Recline the seat to gain enough room to remove the AHR (3).
Press the release button (1) on the left side headrest master sleeve.
Using a thin wire type tool (2), press the hidden release button on the right side headrest slave sleeve.
CAUTION:
Special care should be taken not to damage to the AHR connector.
Slowly lift the AHR (3) up while pressing the buttons simultaneously.
Watch the connector as it reaches the bottom of the tube and guide the connector through.
Remove the AHR (3) fully.