LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Power Locks (Service Information)) >> Standard Procedure >> Standard Procedure - Automatic Door Lock And Unlock >> Customer Programming >> Automatic Unlock (Unlock On Exit)

Automatic Unlock (Unlock On Exit)

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the driver door, sit in the driver seat and close the driver door.
  2. Turn the ignition switch to the ON  position (without starting the vehicle) and then back to the OFF  position. Repeat this cycle three additional times for a total of four ignition switch cycles.
  3. Within 10 seconds of switching the ignition switch to the OFF  position at the end of the fourth cycle in the above step, press the driver interior door lock switch in the UNLOCK  direction to unlock the doors.
    NOTE:

    Steps 2 and 3 must be completed within 10 seconds.

  4. A single chime will be heard to verify that the customer programmable toggle of the automatic door unlock was successfully completed.
NOTE:

When toggling the automatic door unlock (unlock on exit) feature, the toggle that occurs will depend upon the last state of the automatic door unlock feature. If the automatic door unlock feature was enabled, it will now be disabled; and, if it was disabled, it will now be enabled. There is no telltale to inform you of the current state of the automatic door unlock feature. The vehicle must be driven with the doors unlocked to a speed above 24 kilometers per hour (15 miles per hour) to lock the doors, then be brought to a full stop and the driver door opened to confirm whether or not the automatic door unlock feature is now enabled.

scientia non olet · About LEMON Manuals