Automatic Lock (Rolling Locks)
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
- Open the driver door, sit in the driver seat and close the driver door.
- Turn the ignition switch to the ON position (without starting the vehicle) and then back to the OFF position. Repeat this cycle three additional times for a total of four ignition switch cycles.
- Within 10 seconds of switching the ignition switch to the OFF
position at the end of the fourth cycle in the above step, press the driver interior door lock switch in the LOCK
direction to lock the doors.NOTE:
Steps 2 and 3 must be completed within 10 seconds.
- A single chime will be heard to verify that the customer programmable toggle of the automatic door locks was successfully completed.
NOTE:
When toggling the automatic door lock (rolling lock) feature, the toggle that occurs will depend upon the last state of the automatic door lock feature. If the automatic door lock feature was enabled, it will now be disabled; and, if it was disabled, it will now be enabled. There is no telltale to inform you of the current state of the automatic door lock feature. The vehicle must be driven with the doors unlocked to a speed above 24 kilometers per hour (15 miles per hour) to confirm whether or not the automatic door lock feature is now enabled.