Body, Air Cleaner: Installation: Installation
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
- Install the air cleaner body (1) straight down on the three locating pins while engaging the air inlet hose to the throttle body.
- Install the two bolts (5) to the air inlet hose and tighten to 3 N.m (27 in. lbs.).
- Engage the coolant hose to the two retainers (6).
- Install the fresh air makeup hose (2) to the air cleaner body.
- Tighten the clamp (4) at the throttle body to 4 N.m (35 in. lbs.).
- Connect the electrical connector (3) to the Inlet Air Temperature (IAT) sensor.
- Install the engine cover.
Refer to COVER, ENGINE, INSTALLATION .
- Connect the negative battery cable.