LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Lamps/Lighting - Exterior (Service Information)) >> Unit, Headlamp >> Removal >> Lamp - Domestic

Lamp - Domestic

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Headlamp Unit (Domestic)
GC0130812Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the grille panel from the front of the vehicle. Refer to GRILLE, REMOVAL .
  3. Remove the four screws (4) that secure the retainer (3) and the headlamp unit (2) to the mounting collar (1) on the face of the front end module carrier.
  4. Pull the retainer and the headlamp unit away from the front of the vehicle far enough to access the wiring connection on the back of the lamp housing.
  5. Disconnect the engine compartment wire harness connector from the headlamp bulb connector receptacle.
  6. Remove the headlamp unit from the vehicle.
scientia non olet · About LEMON Manuals