Bulb - Position Lamp

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The following procedure applies only to vehicles manufactured for export markets. Vehicles manufactured for domestic markets do not have a position lamp bulb, socket or wiring provided in the headlamp unit.

Fig 1: Identifying Headlamp Bulb (Export)

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the battery negative cable.
Remove the headlamp unit (1) from the mounting collar (3). Refer to UNIT, HEADLAMP, REMOVAL .
Firmly grasp the position lamp socket (5) and pull it straight out of the rubber grommet in the headlamp unit housing.
Rotate the bulb counterclockwise about 30 degrees to unlock it from the socket.
Pull the bulb straight out of the socket.